139.859 - OPTIMUM EUROGOLD

C.A.S.	CONCENTRATION %	Ingredient Name	T.L.V.	LD/50	LC/50
100-42-5	20.76	STYRENE	20 PPM	2650 MG/KG RAT ORAL 316 MG/KG MOUSE ORAL	11800 MG/M3/4H RAT INHALATION 9500 MG/M3/4H MOUSE INHALATION 21000 MG/M3/2H MOUSE INHALATION
85-43-8	1.33	TETRAHYDROPHTALIC ANHYDRIDE	NOT AVAILABLE	3300 MG/KG MOUSE ORAL	NOT AVAILABLE

Section 3: PHYSICAL DATA

Melting point (°C):

Not available

Physical state:

Paste

Appearance & odor:

White

Aromatic

Odor threshold (ppm):

Not available

pH:

Neutral

Specific gravity @ 20 °C:

Not available

Initial boiling point/Boiling range (°C):

145°C

Vapour pressure (mmHg):

@ 20°C (68°F)

5 mmHg

Vapour density (air=1):

Heavier than air

Vapors that evolve from this product will tend to settle and accumulate near the floor

Freezing point (°C):

-30.6°C (-23.1°F)

Evaporation rate
(butyl acetate = 1):

Not available

By volume:

Not available

Solubility in water (%):

Not available

Coefficient of water\oil dist.:

1.36

VOC:

Not available

Viscosity:

60,000 - 78,000

Solid content:

Not available

Density:

Not available

Relative density:

1.06

Section 4: FIRE & EXPLOSION DATA

Flammability:

Flammable

Conditions of flammability:

Vapours are heavier than air and may travel along the ground and be ignited by flames, sparks or other ignition sources at locations distant from the material handling point

Heat, sparks and open flames

Extinguishing media:

Dry chemical

Carbon dioxide

Alcohol-resistant foam

Use water spray

Water may be ineffective

Special procedures:

Firefighters should wear the usual protective gear

Wear a self contained breathing apparatus

Fight fire from a safe distance

This material may produce a floating fire hazard

Flash point (°C), method:

28°C (82°F)

Auto-ignition temperature (°C):

490°C (914°F)

Upper flammability
limit (% vol):

Not available

Lower flammability
limit (% vol):

Not available

Hazardous combustion products:

Oxides of carbon (CO, CO2)

Sensitivity to static discharge:

Not available

Sensitivity to mechanical impact:

Not available

Rate of burning:

Not available

Explosive power:

Vapours may form explosive mixture in air

Lower explosive limit:

1.1%

Upper explosive limit:

6.1%

Section 5: REACTIVITY DATA

Chemical stability:

Product is stable under normal handling and storage conditions

Conditions of instability:

Not available

Hazardous polymerization:

Not available

Incompatible substances:

Strong acids

Peroxides

Strong oxidizing agents

Hazardous decomposition products:

Carbon monoxide

Carbon dioxide

Hydrocarbons

Phthalic anhydride

Section 6: TOXICOLOGICAL PROPERTIES

Route of entry:

Skin contact, eye contact, inhalation and ingestion

Eye contact:

Not available

Skin contact:

May cause allergic reaction

Inhalation:

Not available

Ingestion:

Not available

Effects of chronic exposure:

Not available

LD50 of product, species & route:

No LD50 value established for the product

LC50 of product, species & route:

No LC50 value established for the product

Exposure limit of material:

No exposure limit established for the product

Sensitization to product:

Not available

Carcinogenic effects:

Not available

Reproductive effects:

Not available

Teratogenicity:

Not available

Mutagenicity:

Not available

Synergistic materials:

Not available

Section 7: PREVENTATIVE MEASURES

Gloves/Type:

Impervious gloves

Use a barrier cream when using this product

Respiratory/Type:

Respiratory protection may be required to avoid overexposure when handling this product. General or local exhaust ventilation is the preferred means of protection. Use a respirator if general room ventilation is not available or sufficient to eliminate symptoms. Respiratory protection may be required in addition to ventilation depending upon conditions of use

Eye/Type:

Do not wear contact lenses

Chemical safety goggles with side-shields

Footwear/Type:

Safety shoes per local regulations

Clothing/Type:

As required to prevent skin contact

Other/Type:

Eye wash facility should be in close proximity

Emergency shower should be in close proximity

Ventilation requirements:

Local exhaust ventilation is recommended to control emissions near the source

Leak/Spill:

Eliminate all sources of ignition

Absorb with inert material

Evacuate all non-essential personnel

Wear appropriate protective equipment

No smoking in spill area

Collect material for proper disposal

Shut off all sources of ignition and heat

Waste disposal:

In accordance with municipal, provincial and federal regulations

Handling procedures and equipment:

Keep away from heat, sparks, and open flame

Avoid breathing vapors/mists

Use adequate ventilation

Wear personal protective equipment appropriate to task

Wash thoroughly after handling

Avoid contact with skin, eyes and clothing

Launder contaminated clothing prior to reuse

Storage requirements:

Store away from incompatible materials

Keep away from heat, sparks, and open flames

Keep containers tightly closed

Store in a cool, dry and well ventilated area

Special shipping information:

See transportation information

Section 8: FIRST AID MEASURES

Skin contact:

Wash thoroughly with soap and water

Remove contaminated clothing

Seek medical attention if irritation persists

Eye contact:

Immediately flush eyes with running water for a minimum of 15 minutes. Hold eyelids open during flushing. Obtain medical attention immediately

Tilt the head to prevent chemical from transferring to the uncontaminated eye

Inhalation:

Remove victim to fresh air. If not breathing, qualified personnel should administer artificial respiration. Get medical attention

Loosen tight clothing around the person's neck and waist

Ingestion:

Obtain immediate medical attention

Do not induce vomiting

Never give anything by mouth to an unconscious person

Dilute with water or milk

Additional information:

The above information is believed to be correct but does not purport to be all inclusive and shall be used only as a guide. This company shall not be held liable for any inaccuracies

Section 9: ADDITIONAL INFORMATION

Data prepared by:

Conform-Action Data Systems
A division of 2843471 Canada Inc.
wwww.netmsds.com
Tel: (514) 683-2060
E-mail: Support@cads.ca .